Blackmagicdesign HyperDeck Extreme 8K HDR User Manual

Accessories
Rack Mounting HyperDeck Extreme
The HyperDeck Extreme and HyperDeck Extreme Control can be rack mounted into a
broadcast rack or road case using the HyperDeck rack mount kit.
Sitting at three rack units high and half the width of a standard rack, HyperDeck Extreme can
bemounted side by side or individually using the blanking panel provided with the kit.
The HyperDeck Extreme Rack Kit contains the following items:
2 x Rack ears
Attach rack ‘ears’ to the outside edge of
HyperDeck Extreme for mounting in a rack.
1 x Half rack width blanking panel
The blanking panel has a mounting ear on one side
so you can cover the empty rack space if you are
installing a single unit. The illustration shows the
ear on the right side. Simply rotate thepanel 180° to
mount it to the other side.
2 x Support brackets
The T-shaped support brackets attach underneath
the HyperDeck Extreme units where thetwo units
meet at the front and the rear toprovide support.
Screws
8 x M4 10mm
Rack ear
screws
4 x M4 8mm
Blanking panel
screws
15 x M3 5mm
Support
bracket screws
2 x Cable tab insert
Preparing HyperDeck Extreme or HyperDeck Extreme Control
for individual rack installation:
1 Position the blanking panel on one of the sides of your HyperDeck unit, depending on
whether you would like the unit to sit on the right or left of the shelf. The front face of the
blanking panel should be parallel with the front panel of the unit.
91Accessories

Blackmagicdesign HyperDeck Extreme 8K HDR Specifications

General

Brand	Blackmagicdesign
Model	HyperDeck Extreme 8K HDR
Category	DVR
Language	English