Developer Information
61
The server will respond with a list of all supported commands:
201 help:↵
{H elp Te xt}↵
{H elp Te xt}↵
↵
Switching to preview mode
The "preview" command instructs the deck to switch between preview mode
and output mode:
preview: enable: {"true", "false"}↵
Playback will be stopped when the deck is switched to preview mode.
Capturing will be stopped when the deck is switched to output mode.
Controlling device playback
The "play" command instructs the deck to start playing:
play↵
The play command accepts a number of parameters which may be used
together in most combinations.
By default, the deck will play all remaining clips on the timeline then stop.
The "single clip" parameter may be used to override this behaviour:
play: single clip: {"true", "false"}↵
By default, the deck will play at normal (100%) speed. An alternate speed
may be specified in percentage between -1600 and 1600:
play: speed: {% normal speed}↵
By default, the deck will stop playing when it reaches to the end of the
timeline. The "loop" parameter may be used to override this behaviour:
play: loop: {"true", "false"}↵
By default, the deck will start playing from the current position on the
timeline. The “start” parameter may be specified to override the start-point
for playback:
play: star t: {timecode}↵
To Next Page
Loading...
