Name: Blackmagicdesign HyperDeck Studio
Brand: Blackmagicdesign
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Using Your Favorite Editing Software

Final Cut Pro 7

Select a Blackmagic Easy Setup

Apple Final Cut Pro 7

When you install the HyperDeck Software, Blackmagic Easy Setups are automatically installed to

Final Cut Pro 7.

Setting up

Step 1. Launch Final Cut Pro 7 and the Easy Setup window will appear.

Step 2. Click on the popup menu and select the desired Blackmagic Easy Setup. For each video format

(NTSC, PAL and HDTV) you will find a range of Blackmagic compressed and uncompressed

file formats you can choose.

Step 3. Click on the popup menu named Primary Scratch Disk and select your disk array from the

popup menu.

Step 4. Click OK and the Final Cut Pro interface will appear.

Capturing live via Thunderbolt

To capture video live via Thunderbolt from HyperDeck Studio Pro:

Step 1. Select a Blackmagic Easy Setup. Final Cut Pro will sometimes warn that device control has

been set to “non-controllable device”. This is as expected. Click OK and then create a project

with these settings.

Step 2. Choose File > Log & Capture. (Command + 8).

Step 3. Press play on HyperDeck Studio Pro and then press the Now button in the Log and Capture

window. Final Cut Pro will show you a preview of the video you are capturing.

Step 4. Press esc to stop capturing.

If you can't see an image in your video capture window:

Step 1. Quit Final Cut Pro.

Step 2. Launch Blackmagic UltraScope. Note the output video standard that is displayed on the left

side of Ultrascope's Picture Display. Quit UltraScope.

Step 3. Launch Final Cut Pro and set the project preferences to match the standard reported

by UltraScope.

Other manuals for Blackmagicdesign HyperDeck Studio

Questions and Answers:

Need help?

Do you have a question about the Blackmagicdesign HyperDeck Studio and is the answer not in the manual?

General