Understanding the LCD Menus
44
Advanced Menu
The Video Advanced menu provides access to the following user controls.
Clean Cadence – Forces the creation of a clean 3:2 sequence in the output video.
Scene Detect – Scene change detection prevents blending of scenes at scene boundaries.
Source Type – Sets the algorithmic response of the system based on the type of input video being
received.
FRC Aperture – Adjusts the response of filters used during frame rate conversions
Clean Cadence
The Clean Cadence Menu allows you to remove broken, non standard and mixed cadences and creates a
clean 3:2 sequence from a source that originally contained film based material.
On – Selects the Clean Cadence mode
Off – Selects the Normal video mode of operation
The default mode is OFF
Please note that you should only use the Clean Cadence mode when you are certain that your source
material was originated with a 3:2 sequence, such as film transferred to video by a Telecine. If the Clean
Cadence algorithm is used on video rather than a film source, unwanted artifacts may be seen.
Clean Cadence is available for the following format conversions ONLY:
486i59.94 to 486i59.94
486i59.94 to 1080i59.94
1080i59.94 to 486i59.94
1080i59.94 to 1080i59.94
Main Menu
Back
Setup
Ancillary
Data
Noise
Reduction
Video
1
Main Menu
Video
Back
Advanced
Test
Patterns
Proc
Amp
Aspect
Fill
Clip
Color
2
Video
To Next Page
Loading...
Need help?
General
