ii OM0001_L2_R_WM_USAv2.1
2014 by Blink Network, LLC. All rights reserved.
No part of the contents of this document may be reproduced or transmitted in any form or by any means
without the express written permission of Blink Network, LLC (“Blink”). The contents of this document have
been verified by the manufacturer to be consistent with the described components; however, inconsistencies
sometimes occur. Such inconsistencies should be brought to the attention of an Blink representative.
Changes to this manual may be made at any time without notice.
Disclaimer of Consequential Damages
Blink is not responsible for the use or application by any person of the materials in this manual. Blink is not
responsible for damages, either direct or consequential, arising out of or relating to the use or application of
these materials.
®
Blink, Blink Network, and the logo are registered trademarks of Blink Network, LLC.
ANSI
®
is a registered trademark of the American National Standards Institute.
IEC
®
is a registered trademark of the International Electrotechnical Commission.
IEEE
™
is a trademark of the Institute of Electrical and Electronics Engineers, Inc.
SAE J1772
™
is a trademark of SAE International
®
.
Revised cover art, updated screen images, and added new settings information
Updated warnings and insert model conversion information
Updated for Blink Network, LLC.
Blink Network, LLC
a CarCharging Company
435 S 3
rd
Ave.
Phoenix, AZ 85003
Tel: +1 (602) 716-9576
Fax: +1 (602) 256-2606
http://www.carcharging.com
To Next Page
Loading...
