OM0001_L2_R_WM_USAv2.1 49
A Power Fault Ocurred screenindicates that a power fault has occurred. Your Blink charger will
attempt to clear the power fault automatically. After 4 unsuccessful automatic reset attempts, a manual
reset is required. At any time, touch the screen to manually clear the power fault. If fault fails to clear
(unlikely), contact your Blink Contact Center service representative.
In addition to these screens, an intermittent beep indicates that a power outage has occurred. This
beep stops once the system is either manually reset or resets automatically.
The Blink charging system
shows this screen after a
power fault has occurred.
Touch the screen to reset
the system, or unplug the
vehicle and plug it back in.
To Next Page
Loading...
