16
Follow these instrucons to charge your Baery properly:
1. Locate your Nomad Baery.
2. Locate your Nomad Baery Charger.
3. Unscrew the Dust Cap of the Baery.
4. Plug the Baery Charger into a wall outlet.
5. Aach the Baery Charger connector to the Baery.
6. Conrm the Baery is being charged (LED is red.)
7. Monitor the Baery and Baery Charger unl the LED turns green.
7.2 Charging the Baery
The Baery can be charged from zero to 100 percent capacity in about 3 hours. The Baery has a Dust
Cap aached to the connector. The Dust Cap should be installed by pushing it onto the connector whenever the
Baery is not connected to Nomad’s waterproof Power Connector. The Dust Cap does not create a waterght seal
and the Baery should never be placed underwater unless it is properly connected to Nomad’s Power Connector.
•Do not touch contacts together.
•Do not disassemble or modify the Baery.
•Do not put the Baery in a damp place when not connected to Nomad.
•Assure connector is ght with O-ring in place before use.
•Baery pack is only waterproof with mang connector connected.
•Store in a cool, dry place.
•Use only with approved charger.
•Maximum depth rang: IP67 / 1 meter.
•Do not use or charge under high temperature.
•The baery pack should be charged at least once every 3 months during non-use.
•Do not allow the baery to be near ammable sources.
•Do not store at temperatures above 140 degrees Fahrenheit/40 degrees Celsius.
•Do not store at temperatures below -4 degrees Fahrenheit/-20 degrees Celsius.
•Never leave baeries unaended while charging.
7 Preparing for Your First Startup
The Baery and Baery Charger show manufacturer’s warnings that must be read and understood by the user.
Failure to comply with the Baery and Baery Charger warnings could lead to serious injury or death.
7.1 Baery and Baery Charger Warnings:
Baery and Nomad Power Connector
Rechargeable baeries have an inherent risk of re and explosion. Do NOT leave unaended while charging.
Baery Charger Baery
LED