blu3 Nomad - If the Dive Harness Is Damaged; If the Harness Attachment Point Is Damaged

47
If the Dive Harness becomes damaged, do NOT dive with the Nomad unl the Dive Harness has been replaced.
Diving with a damaged Dive Harness could result in out-of-air hazards.
13.10 If the Dive Harness is damaged
The Dive Harness secures the Air Hose to the user’s body and when adjusted properly prevents
strain on the Mouthpiece. If your Dive Harness is damaged, do NOT dive, refer to diveblu3.com/support for
a replacement, then follow the instrucons in Secon 14.6 on Page 52.
13.11 If the Harness Aachment Point is damaged
The Harness Aachment Point secures the Air Hose to the Dive Harness and when adjusted
properly prevents strain on the Mouthpiece.
If the Harness Aachment Point becomes damaged, do NOT dive with the Nomad unl the Harness Aachment
Point has been replaced. Diving with a damaged Harness Aachment Point could result in out-of-air hazards.
Follow these instrucons to replace your Harness Aachment Point:
1. Obtain a new Harness Aachment Point by referring to diveblu3.com/support.
2. Using a T10 Torx screwdriver, loosen each of the two screws holding the Harness Aachment Point
together.
3. Remove the Harness Aachment Point halves and screws and discard them.
4. Lay the Air Hose on a at table.
5. At the desired distance from the Smart Reg to the Dive Harness, place the Air Hose between the two
halves of the Harness Aachment Point.
6. Align the ridges of the Air Hose with the grooves in each half of the Harness Aachment Point such
that the two halves are ush with each other and not pinching any part of the Air Hose.
7. Using a T10 Torx Screwdriver ghten the screws evenly, alternang from one screw to the other unl
both are snug.
8. Gently pull the Air Hose away from the Harness Aachment Point to conrm it does not slide through
the Harness Aachment Point. Do NOT pull with excessive force which could damage the Air Hose.
9. If the Air Hose slides through the Harness Aachment Point, ghten the two screws ghter and repeat
steps 9 and 10. Do NOT over-ghten as this could snap the screws in half.
10. If the Air Hose sll slides through the Harness Aachment Point, refer to diveblu3.com/support.