blu3 Nomad - If Nomad Is Not Pumping Air or Air Flow Is Limited

51
14.5 If Nomad is Not Pumping Air or Air Flow is Limited
If Nomad is not pumping air when you inhale on the Smart Reg or press the Purge Buon, try each of the
following steps before referring to diveblu3.com/support for addional informaon.
• Conrm the Smart Reg Knob is set to the ON posion, as shown in Figure 8.6.1 on Page 31.
• Conrm the Baery is connected.
• Conrm the Baery is charged.
• Conrm the Intake Plug is not installed.
• If the Intake Plug was installed at the me the Baery was connected, disconnect the Baery, remove
the Intake Plug and then reconnect the Baery.
• Aer disconnecng and reconnecng the Baery, conrm the audible beeps prior to the startup tone is
3 or less. For more informaon, refer to Secon 14.1 on Page 48.