blu3 Nomad - Installing the Dive Flag

18
7.4 Installing the Dive Flag
The Dive Flag is used to indicate that a diver is present in the water. Prior to diving, the user must review local
dive ag laws to decide which diver-down ag to display. Depending on the locaon, either the Alpha Dive Flag
(blue-and-white) or the Red-and-White Dive Flag must be installed onto the Snorkel Tube.
Follow these instrucons to install the Dive Flag:
1. Remove the Drip Cap from the Snorkel Tube.
2. Decide which Dive Flag is appropriate for your dive locaon.
3. If the wrong Dive Flag is on the Snorkel Tube, remove it by pulling the boom of the Snorkel Tube out from
the black elasc at the boom of the Dive Flag.
4. Install the correct Dive Flag by inserng the top of the Snorkel Tube into the black elasc at the boom of
the Dive Flag
5. Slide the Snorkel Tube through the elasc unl the Snorkel Tube extends out of the top of the Dive Flag by
about 1.25 inches.
6. Replace the Drip Cap by pressing it down on top of the Snorkel Tube.
Snorkel Tube Diagram
Upper
Snorkel Tube
Snorkel Tube
O-rings
Dive Flag
Always use the proper Dive Flag while diving. Absence or improper use of a “diver
down” Dive Flag will increase risk of being struck by watercra, which could result in
serious injury or death.
Drip Cap
Lower
Snorkel Tube
Snorkel Tube
Union