blu3 Nomad - Powering Up

27
8.2 Powering Up
10. Count any audible beeps that are prior to the musical startup tone.
8. Remove the intake plug on top of the Nomad handle. This is crical to the startup - do not forget to do this!
9. Insert Power Cable to Baery Connector unl you hear/feel a click and prepare to listen for audible beeps
from Nomad.
7. Remove the Baery Door and posion the Baery so that it is parally installed, providing easy access to
the Power Cable.
11. If there are more beeps than the musical startup tone, refer to Secon 14.1 on Page 48 for informaon on
the meaning of audible beeps.
12 Conrm that the connector is fully installed.
13. Insert the Baery into the Baery Compartment and install the Baery Door unl it is fully seated. The lip
of the Baery Door should mate with the groove in the Baery.
Inserng Baery into the
Baery Compartment (No. 7)
Power cable connector connected
to Baery (No. 8)
A parally ghtened baery connector can allow water to touch the baery contacts. This may result in a failure
of the Baery and result in an out-of-air situaon. Always conrm the Power Cable connector is fully installed
onto the Baery Connector prior to the use of Nomad.
Fully threaded connectors with baery
and baery door completely installed
Removal of Intake Plug
is Crical for Start-up
Plug is located on
Nomad’s Handle
Always keep the Baery Door installed while operang Nomad. Operang Nomad with the Baery Door removed
may lead to electrical shock which may lead to serious injury or death. Do NOT operate Nomad if the Baery
Door is removed.