blu3 Nomad - Installing the Snorkel Tube

30
8.4 Installing the Snorkel Tube
14. Check local diving regulaons and conrm that the proper Dive Flag is installed onto the Snorkel Tube.
If you do not have the proper Dive Flag, you will need to order one from BLU3 at diveblu3.com/support.
Refer to Secon 7.4 on Page 18 for instrucons on installing or replacing your Dive Flag.
Absence or improper use of a “diver down” Dive Flag will increase risk of being struck by watercra, which could
result in serious injury or death.
Damage to the Snorkel Tube O-rings or Drip Cap can result in decreased system performance and water
intrusion to the air supply, causing out-of-air hazards. Do not operate Nomad before conrming the Snorkel
Tube is properly assembled and installed.
15. Connect the Lower Snorkel Tube by inserng it into the Snorkel Tube Union. Install the Snorkel Tube by gently
pressing the double O-ring end into the Nomad Intake orice such that both O-rings are fully inside the Intake.
Be sure the O-rings remain in their grooves when inserted; remove and repeat if the o-rings are dislodged from their
grooves during inseron.
16. Conrm the Drip Cap is pressed down fully on top of the Snorkel Tube to prevent foreign debris and
water from entering the air intake.
Red-and-White
Dive Flag
Drip Cap
*Alpha Dive Flag
Dive Flag Illustraon