blu3 Nomad - Adjusting the Harness Attachment Point

19
7.5 Adjusng the Harness Aachment Point
The Harness Aachment Point is installed on the Air Hose near the Smart Reg and is adjustable so that the user
can modify the length of hose between the Harness Aachment Point and the Smart Reg. It is important the
proper length be set so the user has no restricons of head movement while diving. The proper length will change
based on each user.
Follow these instrucons to adjust the Harness Aachment Point:
1. Hold the Smart Reg Mouthpiece in your mouth with your le hand.
2. Hold the Air Hose with your right hand and place it on the back of your neck.
3. Rotate your head in all direcons.
4. Observe the length of the Air Hose and check for tension or excess hose length.
5. Adjust your right hand unl the hose length is the proper length. It should be long enough
to not cause any tension, and short enough to not bunch up.
6. Keep your right hand in place on the Air Hose.
7. Gently place the Air Hose on a at surface free of sharp objects.
8. Keep note of where your right hand was placed on the Air Hose.
9. Gently rotate the Harness Aachment Point unl it is located in the spot that your right hand was holding
the Air Hose on your neck.
Rotate the Harness Aachment Point to increase or decrease the Air Hose length
to the Smart Reg.
Always check and adjust the Harness Aachment Point prior to diving. If the Air Hose
length is too short for the user, the Smart Reg could be pulled from the user’s mouth
while diving, leading to an out-of-air situaon.