blu3 Nomad - Page 26

26
3. Ensure the Smart Reg Knob is rotated to the OFF posion. The knob is in the OFF posion when it is
rotated counterclockwise unl it stops.
4. Ensure the Baery is suciently charged.
5. Inspect the gold-colored electrical contacts to ensure there is no physical damage or corrosion. There are
four contacts on the Power Cable and two on the Baery Connector.
6. Inspect the Power Cable Connector to ensure that the o-ring is present, without damage or dirt.
Knob in OFF posion
It is advised to always begin a dive with a fully charged Baery.
Damage or corrosion to the electrical contacts may reduce system performance and result in insucient air ow
and lead out-of-air hazards. Do not operate Nomad if corrosion exists on any of the electrical contacts.
Refer to Secon 13.3 on Page 45 for instrucons on cleaning electrical contacts.
Damage or absence of the Power Cable O-ring can allow water to touch the baery contacts, which may result in
a failure of the Baery and result in out-of-air hazards. Do not operate Nomad if the O-ring is absent, dirty
or damaged.
Power Cable O-ring in the Power Cable Connector
To order a replacement O-ring, diveblu3.com/support