To access and view the FACTORY MENU, follow these steps:
1. Flight strips should be loaded into the printer with the printer powered on.
2. Press and hold the MENU button first, and while continuing to keep the MENU button
depressed, press and hold the ON/OFF LINE button for approximately for about 3 seconds.
The LCD will display FACTORY MENU or start scrolling through different settings. Release the
buttons as this time.
3. To scroll through the menu topic, use MENU button to select the topic you wish to view.
4. Press ON/OFF LINE button to scroll through choices in the selected topic. NOTE: A blinking
cursor next to a choice indicates that choice is currently saved in the printer’s memory.
5. Press the MENU will enable you to select other topics.
To access and change the FACTORY MENU, follow these steps:
1. Make sure the printer is powered off.
2. Press and hold both the MENU and ON/OFF LINE buttons. While holding the two buttons
power up the printer. Within about 3 seconds the LCD will display FACTORY MENU or start
scrolling through different topics. Release the buttons as this time. WARNING: Improper use
of the factory menu may disable your printer.
3. To scroll through the menu topic, use MENU button to select the topic you wish to change.
4. Press ON/OFF LINE button to scroll through choices in the selected topic. NOTE: A blinking
cursor next to a choice indicates that choice is currently saved in the printer’s memory.
5. Once you have found the new value you want, press BLANK STRIP button. The LCD window
displays EXIT AND SAVE? If you wish to save the new value then press BLANK STRIP
button again.
6. If you do not wish to save the new value then press MENU. The LCD window displays JUST
EXIT? Press BLANK STRIP button to exit the FACTORY MENU without saving new values or
press MENU to enter back into the FACTORY MENU.
To Next Page
Loading...
