Boca Systems LEMUR-FDIO - Page 18

14
The chart below lists the present menu topics. These topics are subject to change.
The following is a brief overview of some representative Menu options:
STRIP SELECTION? Select blank flight strip format to be assigned to blank strip button on the control panel.
DOMESTIC
Domestic Strip - 1.0 x 8.0 inches - NSN 7530-01-453-5094 (default)
Domestic ½ Strip - 1.0 x 8.0 inches - NSN 7530- 01-468-4668
OCEANIC
Oceantic Strip - 1.317 x 8.0 inches - NSN 7530-01-435-1872
INC CUT1 COUNT? Moves the cut position to the left (towards the ticket entrance area). Cut counts are increments of
.003”. Depressing CHOICES changes the count value. 16 is factory default. For a 300dpi printer the INC value should
not exceed 35. Going beyond these values will cause reliability issues.
DEC CUT1 COUNT? Moves the cut/ position to the right (towards the ticket exit area). Cut counts are decrements of
.003”. Depressing CHOICES changes the count value. 16 is factory default.
PRINT INTENSITY? Controls the darkness of printout. Here are the following choices:
LIGHT
MED LIGHT
NORMAL
(factory default)
MED DARK
SHORT HEAD LIFE
BAUD RATE? Controls the serial interface: baud rate, parity bit, data bits and stop bits. Here are the following choices:
(2400,N,8,1 is default)
1200,N,8,1
4800,N,8,1
19200,N,8,1
38400,E,7,1
1200,E,7,1
4800,E,7,1
19200,E,7,1
57600,N,8,1
1200,O,7,1
4800,O,7,1
19200,0,7,1
57600,E,7,1
2400,N,8,1
9600,N,8,1
28800,N,8,1
115200,N,8,1
2400,E,7,1
9600,E,7,1
28800,E,7,1
115200,E,7,1
2400,O,7,1
9600,0,7,1
38400,N,8,1
OPERATOR MENU
STRIP SELECTION?
INC CUT1 COUNT?
DEC CUT1 COUNT?
PRINT INTENSITY?
BAUD RATE?
MINI/MICRO?
PRINT SPEED?
DIAGNOSTIC MODE?
TICKET TYPE?
STATUS ENABLED?
PAPER MODE?
CLEAR DOWNLOAD?
DEFAULT SETTING?
PARK TICKET?
TICKET MODE?
INC MINIREV?
DEC MINIREV?
INC TOP ADJ?
DEC TOP ADJ?
USB?
USB DEVICE TYPE?
ETHERNET?
IP ADDRESS?
SUBNET MASK?
DEFAULT GATEWAY?
DNS SERVER?
SPEED/DUPLEX?
EXIT AND SAVE?
JUST EXIT