Boca Systems LEMUR-FDIO - Page 19

15
MINI/MICRO? Defines if printer has a cutter. Factory set do not modify.
MINI cutter (default)
MICRO no cutter
PRINT SPEED? Controls the print speed and the print quality. Printer should not be run at a print speed of 0 as it may
cause ticket
jams. The numbers range from 0 - FASTEST to 7 - SLOWEST. (3 is factory default).
DIAGNOSTIC MODE? Your choices are YES or NO. NO is factory default. YES places the printer into a mode where it
prints both printable and control characters to assist in isolating data transmission issues. (NO is default)
TICKET TYPE? Defines how the optos are configured on the paper guide assembly. (FACTORY PRESET / SHOULD
NOT BE CHANGED)
NORMAL
Both optos are in line with each other (usually mounted on a black bracket)
GAP
A gap opto is installed on the cutter to detect gap in ticket stock.
LABEL
Same as GAP but the cut opto is to detect black mark on stock.
SPECIAL TICKET
This option is for a Micro MB or a printer with a ticket load switch (default)
STATUS ENABLED? Sets status response protocols. (FACTORY PRESET / SHOULD NOT BE CHANGED)
NONE
Disables the XON/XOFF and status response protocols
SERIAL
Enables the XON/XOFF and status response protocol for the serial port
PARALLEL
Enables bi-directional parallel status responses if printer is configured as bi-directional
SER/PAR
Enables both bi-directional parallel and serial status responses.
USB
Enables USB status responses
USB/SER
Enables USB and serial status responses (default)
USB/PAR
Enables USB and bi-directional parallel
USB/SER/PAR
Enables USB, bi-directional parallel and serial status responses
PAPER MODE? It may also be used on roll stock with no black marks on the ticket. (FACTORY PRESET / SHOULD
NOT BE CHANGED).
YES
Configured for use with media that does not have a black timing mark.
NO
Paper mode disabled (default)
RECEIPT
Only for a Lemur-R & Lemur-C receipt model printers
PARTIAL CUT
Enables both bi-directional parallel and serial status responses.
PARTIAL CUT ###
Only for Lemur-R & Lemur-C receipt model printers set to partial cut mode.
RX MODE
Enables USB and serial status responses
CLEAR DOWNLOAD? Clears those items downloaded by the operator to Flash memory. Your choices are YES or NO.
(NO is default)
DEFAULT SETTING? Defaults the printer back to its original factory settings. Your choices are YES or NO. (NO is
default)
PARK TICKET? Reverse the ticket to the print position after the last strip in a group has been printed. Your choices are
YES or NO. (YES is default) (FACTORY PRESET / SHOULD NOT BE CHANGED)
TICKET MODE? Defines how the printer will treat multiple flight strips. Your choices are SINGLE or MULTIPLE.
(SINGLE is factory default).
INC MINIREV? Allow horizontal positioning of the flight strip data within the printable area of flight strip to be adjusted.
This control is primarily used to adjust the print position right at the factory and is not normally needed during normal
printer operation. (0279 is default value)