Boca Systems LEMUR-FDIO - Page 20

16
DEC MINIREV? Allow horizontal positioning of the flight strip data within the printable area of flight strip to be adjusted.
This control is primarily used to adjust the print position left at the factory and is not normally needed during normal printer
operation. (0279 is default value)
INC TOP ADJ? Allow vertical positioning of the flight strip data within the printable area of flight strip to be adjusted. This
control is primarily used to adjust the print position down at the factory and is not normally needed during normal printer
operation. (0001 is default value)
DEC TOP ADJ? Allow horizontal positioning of the flight strip data within the printable area of flight strip to be adjusted.
This control is primarily used to adjust the print position up at the factory and is not normally needed during normal printer
operation. (0001 is default value)
USB? Activates the USB interface. Your choices are YES or NO. (YES is default) (FACTORY PRESET / SHOULD
NOT BE CHANGED)
USB DEVICE TYPE? Enables the printer’s USB device class to be changed. Your choices are PRINTER, HID and serial.
(Default is HID).
ETHERNET? Enables the Ethernet port setting to be changed.
NO
Ethernet not enabled
YES
Uses the IP address that has been set in the printer by the customer or manual
selection
Diagnostics
This feature should not be used
Valid Packets
This feature should not be used
DHCP Enabled
Automatically attempts to get an IP address from Local Server (Default)
DHCP/SUB/GATE
Automatically attempts to get an IP address/Subnet Mask/Gateway from Local Server
DHCP/NR
Automatically attempts to get an IP address from Local Server and then register the
name with the local NetBIOS name server usually the WINS Server
DHCP/SUB/GATE/NR
Automatically attempts to get an IP address/Subnet Mask/Gateway from Local Server
and then register the name with the local NetBIOS name server usually the WINS
Server
IP ADDRESS? Enables the printer’s Ethernet IP Address to be manually changed. 000.000.000.192 is default if Ethernet
port is not connected to the network.
SUBNET MASK? Enables the printer’s Ethernet Subnet Mask value to be changed. 0.0.0.0 is default if Ethernet port is
not connected to the network.
DEFAULT GATEWAY? Enables the printer’s Ethernet default Gateway value to be changed. 010.000.000.192 if Ethernet
port is not connected to the network.
DNS SERVER? Enables the printer’s Ethernet default DNS server value to be changed. 000.000.000.192 is default if
Ethernet port is not connected to the network.
SPEED/DUPLEX? Enables the printer’s Ethernet speed and duplex setting to be changed. Your choices are AUTO-
NEGOTIATE (default), 100Mbps/FULL, 100Mbps/HALF, 10Mbps/FULL and 10Mbps/HALF.
EXIT AND SAVE! Will save any changes made to the above menu options. If you wish to save the new value then press
ON/OFF LINE button, if not press MENU button.
JUST EXIT? Will exit the menu options without saving any changes. If you wish to exit without saving the new value then
press ON/OFF LINE button, if not press MENU button.