13. Install the drive belt back on the pulleys. Slide the stepper motor back just enough to take up
the belt tension and tighten the four Philip head screws.
14. Grab onto the driver belt and turn it a few times. You want to make sure the platen still moves
freely. There should be no binding. If there is binding then you may have too much tension on
the drive belt. Adjust if needed.
15. Install the cutter assembly back onto the print cage and make sure the ground wire is
attached back on as shown in step #4.
16. Install the head plate/ print head back in place and lock the cam lock lever.
17. Install the electronics cover back in place. You will need to make sure that the two wire tabs
go back through the 1⁄4” Hex head screw.
18. Install the drive belt shield back in place.
19. The printer may now be put back into service.
To Next Page
Loading...
