Disassembly-Assembly of service kits
Safety remarks
Installation of service kits
In principle, the same safety remarks described on page 5 of this Service Manual are valid.
Furthermore the following should be taken into account:
Before starting any work on the compressor:
Switch of the machine and guard it against switching on
Close the discharge and suction shut-off valves
Relieve the compressor from system pressure
Use only genuine Bock spare parts.
Connect the safety switch and check its function
Evacuate the compressor
Before commissioning, check whether all the components installed by the user have
been mounted expertly and connected pressure-tight to the compressor (e.g. piping,
plugs, union nuts, replaced components etc.)
Open the pressure and suction shut-off valves (see page 11)
Set off the switching-on lock
After the work is finished:
For changing components in the framework of customary service works we recommend the kits
described on the following pages.
- 17 -
09608-09-03-DGbFEI
To Next Page
Loading...