Electromagnetic clutch
Assembly instruction for electromagnetic clutch
For the drive of A/C compressors in buses, mainly electromagnetic clutches are used. The
followings assembly instructions for clutch type LA 16 is representative for clutches which are
mounted onto the front bearing flange of the compressor.
Assembly instruction for electromagnetic clutch Type LA 16
The front bearing flange has a locationg face
Ø 148h8 for fitting the solenoid of the electro-
magnetic clutch (see Fig. 9).
Fig. 9
Fig. 10
Front bearing
flange
Magnetic
field
For fitting the solenoid (1) remove the four M8 x 25 cylinder screws (2) on the bearing
flange (indicated with circles and arrows in Fig. 9 on page 23 and Fig. 11 on page 24).
Fit the solenoid onto the locating seat and fasten it again with the four M8 x 25 cylinder
screws (Fig. 10). Observe the screw tightening torque (see Table on page 55)!
Attention! Use only M8 x 25 screws! Otherwise, serious damages may occur on
the electromagnetic clutch and the compressor.
09608-09.03-DGbFEI
- 23 -
Ø
To Next Page
Loading...