Bosch D9068 - 5.4 Programming the D9068; 5.4.1 PROG TIME

D9068 | Operation and Installation Guide | 5.0 Programming
.
Bosch Security Systems, Inc. | 3/13 | F01U071094-07
37
5.4 Programming the D9068
The D9068 uses scrolling menus to show
the menu choices. The Main Menu shows:
SYSTEM NORMAL
0: PROGRAM
1: STATUS
2: HISTORY
3: TEST
4: RESET
To enter the Programming Menu, press
[0]. The Programming Menu shows:
1: PROG TIME
2: PROG TIMERS
3: PROG INPUTS
4: PROG RELAY
5: PROG ACC’NTS
6: PROG FORMATS
7: PROG DEFLTS
8: SERIAL CONECTN
When you enter the Programming
Menu (Level 2), you no longer
need to press [0] to re-enter
the Programming Menu. If you
press [0] while already in the
Programming Menu, the keypad
emits a three-beep error tone.
5.4.1 PROG TIME
The PROG TIME feature provides
programming options for setting the
system date and time, establishing
automatic testing times, and adhering to
Daylight Saving Time.
To access the PROG TIME programming
options:
At the Programming Menu, press [1] to
select
1: PROG TIME. The window shows:
DATE/TIME
1: SYSTEM
2: AUTO TEST
3: DAYLIGHT SAV
Refer to the following sections for the
PROG TIME programming options.
1: SYSTEM
To access SYSTEM, select [0]: PROGRAM
[1]: PROG TIME[1]: SYSTEM. This option
allows you to set the current date and
time for system operations.
To set the current date and time for
system operations:
1. At the Prog Time submenu, press [1]
to select
1: SYSTEM. The window shows:
ENTER DATE
MMDDYY: _________
2. Enter the date and press [# Command]
to accept the entry.
3. Press [* Clear] to move to the next
feature.
ENTER TIME
HHMM: ___________
4. Enter the time in 24-h format and
press [# Command] to accept the
entry.
5. Press [* Clear] to return to the Prog
Time (Date/Time) scrolling menu. The
keypad shows the entries that were
made before returning to the Prog
Time Menu.
2: AUTO TEST
To access AUTO TEST, select [0]:
PROGRAM
[1]: PROG TIME[2]: AUTO TEST. This
option allows you to set the time when
the Auto Test is sent and how often the
Auto Test occurs.
To set the time when the Automatic Test
is sent and how often an Auto Test
occurs:
 At the Prog Time submenu, press [2]
to select2: AUTO TEST. The window
shows:
AUTOMATIC TEST
1: TEST TIME
2: TEST FREQUENCY
Refer to the following sections for the
Automatic Test programming options.
2: TEST FREQUENCY
To access TEST FREQUENCY, select
[0]: PROGRAM[1]: PROG TIME[2]:
AUTO TEST[2]: TEST FREQUENCY. Choosing
this option allows you to program how
often the Auto Test Reports are sent.
The first test is sent when the system
time matches the next programmed test
time. Subsequent reports are sent to the
selected intervals.