Bosch D9068 - Page 73

D9068 | Operation and Installation Guide | Appendix F: D8024/D10024/D10024A Analog
FACP Operation
.
Bosch Security Systems, Inc. | 3/13 | F01U071094-07
73
Table 23: Analog Reports and Causes (Continued)
Analog FACP
Event
Comments
Cause
Network Failure
Control panel
generated.
A network failure is detected.
Remote
Programming
Failed*
Future
There is a problem with programming.
Remote
Programming
Successful*
Future
The remote programming is successful.
Control Panel
Communication
Failure
Dialer generated.
The control panel lost communication.
Control Panel
Communication
Restore
Dialer generated.
This message is sent if control panel
communications are restored. If the were any off-
normal control panel conditions prior to losing
communications, and the control panel is normal, a
System Reboot Reset is also sent when
communications are restored.
System Trouble -
Keypad Installed
Dialer generated.
No keypad activity for 3 minutes.
System Trouble -
Restoral Keypad
Installed
Dialer generated.
The keypad trouble is restored.
System Trouble –
Communications
Fault
Dialer generated.
There is a communication error.
System Trouble
Restoral -
Communications
Fault
Dialer generated.
The communication is restored.
System Trouble -
Programming
Error
Dialer generated.
There is a programming error.
System Trouble
Restoral -
Programming
Dialer generated.
The programming error is restored.
Invalid Events
32 to 39, 94 to
255
Not valid.
* Event is not supported at this time.