Bosch DCN Next Generation - Dcn-Idenc ID-Card Encoder; Dcn-Idcrd ID-Cards

The following sections give more information about the mentioned subject:
– Connection: DCN-DDB Data Distribution Board, page 151.
– Configuration: DCN-DDB Data Distribution Board, page 228.
– Operation: DCN-DDB Data Distribution Board, page 255.
DCN-IDENC ID-card Encoder
Use the DCN-IDENC ID-card Encoder and the ID-Card Encoder software module, to configure
DCN-IDCRD ID-cards.
The following sections give more information about the mentioned subject:
– Technical Data: DCN-IDENC Chip Card Encoder, page 287.
DCN-IDCRD ID-cards
With the DCN-IDCRD Chip Cards delegates and chairmen can identify themselves to the
system. Use the chip cards to give the delegates and chairmen access to:
– The microphones of the contribution devices.
– The voting functions on the contribution devices.The intercom functions on the
contribution devices.
Figure 3.70: ID-card
Notice!
Use the DCN-IDENC ID-card Encoder to configure the ID-cards.
Notice!
Labels that are larger than 72 x 24 mm can be used on the rear of the chip card.
Notice!
Refer to the Delegate Database Software User Manual for instructions to find the code of the
card in the chip.
3.39
3.40
Conference System System Overview | en 63
Bosch Security Systems B.V. Operation Manual 2013.11 | V2.0 | DCN-NG_OM_V4.x