-61-
Troubleshooting
Problem Cause Corrective Action
Blade Bevel Lock Handle
Elevation Wheel hard to move.
Blade Bevel Lock Handle 3 not
loosened.
See the “Blade Bevel Lock Han-
dle” explanation in “Getting to
Know Your GTS15-10 Table Saw”
on page 12.
Saw dust on the threads of the
Threaded Elevation Rod 118.
See “Cleaning” on page 57.
Undercarriage lled with saw
dust.
Frequently blow out any dust that
has accu mulated in the undercar-
riage, motor, or blade elevation
gears.
Rip fence will not correctly
clamp to rails.
The Rip Fence 9 is not fully
seated on the Rails 10.
Make sure that both ends of the
Rip Fence 9 are fully seated flush
against the Rails 10 before trying
to latch the Rip Fence Lock Levers
55.
1609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 611609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 61 4/20/2023 11:24:15 AM4/20/2023 11:24:15 AM
To Next Page
Loading...
