MY22B01 - 12_1.0_26.08.2021
102
Operation
6.5.10 Gear shift
Adjust the position of the gear shift to the rider’s
needs.
1 Undo attachment screw.
2 Place control panel or shifter into the position
where the rider can use the control panel or the
shifter with their thumb and/or index finger.
3 Tighten attachment screw.
6.5.10.1 SHIMANO shifter
Only applies to vehicles with this equipment
Figure 111: Position of attachment screw in SHIMANO shifter
Model Tightening torque Screw
DEORE SL-M4100 3 Nm 4 mm hex bit
DEORE SL-M5100 3 Nm 4 mm hex bit
DEORE SL-M6100 3 Nm 4 mm hex bit
DEORE XT SL-M8100 3 Nm 4 mm hex bit
DEORE XT SL-M8130 3 Nm 4 mm hex bit
SLX SL-M7100 3 Nm 4 mm hex bit
XTR SL-M9100 3 Nm 4 mm hex bit
Table 47: Tightening torque and bits for SHIMANO gear shift
All manuals and user guides at all-guides.com
To Next Page
Loading...
