Bosch Intuvia - Preparing the Battery; Retrofitting the Powertube Adapter

MY22B01 - 12_1.0_26.08.2021
62
Assembly
5.3.2 Preparing the battery
5.3.2.1 Retrofitting the PowerTube adapter
Only applies to pedelecs with this equipment
A PowerTube Adapter 400 or 500 needs to be
retrofitted to use a BOSCH PowerTube 625
battery.
1 Use a TORX® T25 wrench to undo the screws
in the battery mount.
Figure 50: Undoing screws on battery mount
2 Use a ratchet to remove the two 4 mm hexagon
screws in the PowerTube adapter. If you don't
have a ratchet, you can use a hexagonal key to
remove the screws.
Figure 51: Removing the 4 mm hexagon screws
3 Use a ratchet to remove the two 4 mm hexagon
screws in the PowerTube adapter.
Figure 52: Removing hexagon screws
4 Pull out the PowerTube adapter.
Figure 53: Pulling out the PowerTube adapter
5 Use adapter plates to adjust the distance if
necessary.
.
Figure 54: Fitted adapter plates
All manuals and user guides at all-guides.com