Bosch Intuvia - Setting the Quill Stem; Adjusting the Ahead Stem

MY22B01 - 12_1.0_26.08.2021
89
Operation
6.5.6.2 Setting the quill stem
Only applies to pedelecs with this equipment
In the case of a quill stem, the stem and fork
steerer form a permanently interconnected
component, which is clamped in the fork steerer.
The stem and shaft must be replaced together.
Figure 95: Adjusting the quill stem height
1 Undo screw.
2 Pull quill stem out.
3 Tighten screw.
6.5.6.3 Adjusting the Ahead stem
Only applies to pedelecs with this equipment
In the case of an Ahead stem, the stem is placed
directly on the fork steerer, which protrudes over
the frame.
Figure 96: Raising the Ahead stem by fitting spacer rings
The handlebar height is adjusted once during
production using spacer rings. The part of the fork
steerer protruding is then cut off. The handlebar
stem can then no longer be raised.
All manuals and user guides at all-guides.com