Bosch Intuvia - Grip Distance on a MAGURA HS22 Brake Lever

MY22B01 - 12_1.0_26.08.2021
96
Operation
6.5.9.5 Grip distance on a MAGURA HS22 brake lever
Only applies to pedelecs with this equipment
The brake lever position can be adjusted to the
rider's requirements.
 Use a T25 TORX® wrench to turn the setting
screw (2) to adjust the grip distance.
1 Push the brake lever gently and hold.
 Move the slider (2) outwards (–) to Position II
or III.
 The brake handle moves closer to the
handlebars.
 The brake linings move closer to the rim.
 The pressure point activates sooner.
 Move the slider inwards (+) to Position II or I.
 The brake lever moves away from the
handlebars.
 The brake linings move away from the rim.
The pressure point activates later.
Figure 107: Setting the grip distance on a MAGURA HS 22 brake lever
Crash caused by incorrectly set grip distance
If brake cylinders are set or installed incorrectly,
braking power may be lost completely at any time.
This may cause a crash with serious injuries.
 Once the grip distance has been set, check the
position of the brake cylinder. Correct if
necessary.
WARNING
!
1
All manuals and user guides at all-guides.com