Bosch Intuvia - Using the Battery; Frame Battery; Removing the Frame Battery; Inserting the Frame Battery

MY22B01 - 12_1.0_26.08.2021
118
Operation
6.16 Using the battery
 Switch off the battery and the drive system before
removing or inserting the battery.
6.16.1 Frame battery
Only applies to pedelecs with this equipment
6.16.1.1 Removing the frame battery
Figure 127: Removing and inserting the frame battery
1 Open battery lock with battery key (1).
2 Tip the battery out of the top section of the
frame battery mount.
3 Pull from the frame battery mount (2).
6.16.1.2 Inserting the frame battery
1 Place the battery on the contacts in the lower
section of the frame battery mount (3).
2 Remove the battery key from the battery lock
(4).
3 Tip the battery into the top section of the frame
battery mount until it will go no further.
 There is an audible clicking noise.
4 Check the battery to make sure it is firmly in
place.
6.16.2 Pannier rack battery
Only applies to pedelecs with this equipment
6.16.2.1 Removing the pannier rack battery
Figure 128: Removing (2) and inserting (3) the pannier
rack battery
1 Open battery lock with battery key (1).
2 Pull the pannier rack battery backwards and
out of its mount (2).
3 Remove the battery key from the battery lock
(1).
6.16.2.2 Inserting the pannier rack battery
1 Insert battery into the pannier rack battery
mount with the contacts facing the front until it
clicks into place (3).
2 Check the battery to make sure it is firmly in
place.
(2)
7°
(1)
(3)
(4)
(1)
(2)
(3)
All manuals and user guides at all-guides.com