MY22B01 - 12_1.0_26.08.2021
46
Description
3.4.2.11 Additional system settings
Applies only to eShift with SHIMANO DI2
automatic hub gears
Applies only to eShift with manual SHIMANO DI2
hub gears
Applies only to eShift with SHIMANO DI2
automatic hub gears.
Applies only to eShift with NuVinci H|Sync/
ENVIOLO with Optimized H|Sync
Display Change
– Start gear + This is where you can set the start
gear. The automatic gear switch
function is switched off in Position
– –. This menu option is only
shown when the on-board
computer is positioned in its
mount.
Gear adjustment You can use this menu option to
make a fine adjustment to the
SHIMANO DI2. You'll find the
specified setting range described
in the gear manufacturer's oper-
ating instructions. Make fine
adjustments if the gear shift
makes unusual noises. This menu
option is only shown when the on-
board computer is positioned in its
mount.
Gear vx.x.x.x: this is the gear software version.
This menu option is only shown
when the on-board computer is
positioned in its mount. This menu
option is only shown if you have
an electronic control gear.
Table 22: Changing the system settings
Display Change
– Start gear + This is where you can set the start
gear. The automatic gear switch
function is switched off in Position –
–. This menu option is only shown
when the on-board computer is
positioned in its mount.
Gear adjustment You can use this menu option to
make a fine adjustment to the
SHIMANO DI2. You'll find the spec-
ified setting range described in the
gear manufacturer's operating
instructions. Make fine adjustments
if the gear shift makes unusual
noises. This menu option is only
shown when the on-board
computer is positioned in its mount.
Gear vx.x.x.x: this is the gear software version.
This menu option is only shown
when the on-board computer is
positioned in its mount. This menu
option is only shown if you have an
electronic control gear.
Table 23: Changing the system settings
Display Change
Gear adjustment You can use this menu option to
make a fine adjustment to the
SHIMANO DI2. You'll find the speci-
fied setting range described in the
gear manufacturer's operating
instructions. Make fine adjustments
if the gear shift makes unusual
noises. This menu option is only
shown when the on-board computer
is positioned in its mount.
Gear recovery You can use this menu option to
reset the rear derailleur if it has
been detached – due to a crash or
impact against the derailleur, for
example. You will find a description
of how to reset the gear shift in the
gear shift manufacturer's operating
instructions. This menu option is
only shown when the on-board
computer is positioned in its mount.
Gear vx.x.x.x: this is the gear software version.
This menu option is only shown
when the on-board computer is
positioned in its mount. This menu
option is only shown if you have an
electronic control gear.
Table 24: Changing the system settings
Display Change
Gear calibration This is where the continuously
adjustable gear is calibrated. You
might need to perform calibration
while riding in the event of a fault.
The menu option is only shown
when the on-board computer is
positioned in its mount
Press on the Lighting button
to confirm calibration.
Follow the instructions.
Gear vx.x.x.x: this is the gear software version.
This menu option is only shown
when the on-board computer is
positioned in its mount. This menu
option is only shown if you have
an electronic control gear.
Table 25: Changing the system settings
To Next Page
Loading...
