1 Important Notes
1.1 Safety Instructions
1.1.1 General Information
● Do not attempt to install and operate the components of the electric drive and control
system without first reading all documentation provided with the product. Read and
understand these safety instructions and all user documentation prior to working with
these components. If you do not have the user documentation for the components,
contact your responsible Rexroth sales partner or check www.boschrexroth.com/
various/utilities/mediadirectory/ for available downloads of safety instructions and in‐
struction manuals. Ask for these documents to be sent immediately to the person or
persons responsible for the safe operation of the components.
● If the supplied documents contain some information you do not understand, it is ab‐
solutely necessary that you ask Rexroth for explanation before you start working at
or with the components.
● If the component is resold, rented and/or passed on to others in any other form,
these safety instructions must be delivered with the component in the official lan‐
guage of the user's country.
● Only qualified persons may work with components of the electric drive and control
system or within its proximity.
In terms of this Instruction Manual, qualified persons are those persons who are fa‐
miliar with the installation, mounting, commissioning and operation of the compo‐
nents of the electric drive and control system, as well as with the hazards this im‐
plies, and who possess the qualifications their work requires. To comply with these
qualifications, it is necessary, among other things,
– to be trained, instructed or authorized to switch electric circuits and components
safely on and off, to ground them and to mark them,
– to be trained or instructed to maintain and use adequate safety equipment,
– to attend a course of instruction in first aid.
● The technical data, connection and installation conditions of the components are
specified in the respective application documentations and must be followed at all
times.
● If the components take the form of hardware, then they must remain in their original
state, in other words, no structural changes are permitted. It is not permitted to de‐
compile software components or alter source codes.
● Do not mount damaged or faulty components or use them in operation.
● Only use accessories and spare parts approved by Rexroth.
● Follow the safety regulations and requirements of the country in which the electric
components of the electric drive and control system are operated.
DOK-RCON01-REX*F*UL***-IN01-EN-P
Rexroth Frequency Converters
Bosch Rexroth AG
Important Notes
19/65
To Next Page
Loading...
