5 Instructions for Use
5.1 Overcurrent Protection
Protect the components against overcurrent:
● Branch circuit protection has to be provided externally
● Dimension the branch circuit protection according to the data "Branch circuit protec‐
tion fuse (UL)" (see Ratings and Dimensions)
5.2 Mounting
5.2.1 General Information on Frequency Converter Mounting
Lethal electric shock by live parts with more than
50 V!
Before working on live parts: De-energize installation and secure power switch against
unintentional or unauthorized re-energization.
Wait at least 30 minutes after switching off the supply voltages to allow discharging.
Check whether voltage has fallen below 50 V before touching live parts!
Damage can be caused to the frequency converter or circuit boards if electrostatic
charging present in people and/or tools is discharged across them. For this reason,
please observe the following information:
Electrostatic charges can cause damage to elec‐
tronic components and interfere with their operation‐
al safety!
Exposed conductive parts coming into contact with components and circuit boards
must be discharged by means of grounding. Otherwise errors may occur when control‐
ling motors and moving elements.
Such exposed conductive parts include:
● The copper bit when soldering
● The human body (ground connection by touching a conductive, grounded object)
● Parts and tools (place them on a conductive support)
Endangered components may only be stored or dispatched in conductive packaging.
DOK-RCON01-REX*F*UL***-IN01-EN-P
Rexroth Frequency Converters
Bosch Rexroth AG
Instructions for Use
39/65
To Next Page
Loading...
