● After connecting the power supply terminals, the motor and the control terminals,
place the cover back before switching on the power. Take account of the following
instructions:
1. Ensure that the power supply can provide appropriate voltage and current. En‐
sure that the rated current range is within that of the frequency converter and
power supply.
2. It is recommended to use 4-core cables to connect the motor. Cables are connec‐
ted to motor terminals PE-U-V-W.
3. If shielded cables are used, the shield layer of the motor cable should be securely
connected to
on the bottom right of the heat sink. The shielded cables for the
control signals should be connected to on control terminal block.
It is recommended to use shielded cables in accordance with specified
EMC classification.
DOK-RCON03-EFC-3600***-IT01-EN-P
Rexroth Frequency Converter EFC 3600
Bosch Rexroth AG
Mounting and Installation
31/235
To Next Page
Loading...
