Bosche EWI - 7 Troubleshooting; In the Event of a Malfunction; Error Messages

Version 4.0
2024-03-27
BOSCHE Weighing Systems
Page 120
Weighing Terminal EWI / MWI Troubleshooting | 7
7 Troubleshooting
7.1 In the event of a malfunction
We recommend switching off the scales briefly and disconnecting it from the
mains, if a malfunction occurs in the program sequence. Then restart the
weighing process.
7.2 Error messages
Error
messages
Malfunction Cause possible Solution
No data Power supply disconnect. Check power supply.
--ErrSCL--
No connection to the
scale/ no data
receiver.
Cable damage.
No cable connected.
No indicator connected.
Check data cable.
Connect the indicator
--OL--
Overload Scale overloaded. Take weight from the scale.
If the problem persists,
please contact your dealer
or the company BOSCHE.
--LEuEL--
Tilt sensor active.
(only for mobile
scales or pallet
trucks).
Mobil scale / pallet trucks is
more inclined than +/- 2 °.
Align mobil scale / pallat
truck.
--Error--
Error while setting
the zero calibration
or the load.
The scale is unstable.
Load cells are not con-
nected properly.
Wait until the scale is stable.
Connect load cells correctly.
2rP.Err
Fault when setting
the new zero.
The scale is unstable.
The weight is outside hte
limits
rn.2Ero for setting
the zero point.
Wait until the scale is stable.
Correct weight.
Er.2Ero
Fault when setting
the new zero.
The scale is unstable.
The weight is outside hte
limits
.2Ero for setting the
zero point.
Wait until the scale is stable.
Correct weight.
Confirm the error with .
TAr.Err
Fault when setting
the tare.
The scale is unstable. Wait until the scale is stable.
PSW.Err
Password is incor-
rect.
Incorrect password entry. Enter the correct password.
aLb.Err
The entered Alibi
value does not exist.
Incorrect Alibi value entered. Enter correct Alibi value.