Bowers M1 - Page 51

M1 – M3 Display units
Page 51
 Zero : (Input) set the current measured value to 0 (relative mode)
 Clear : (Input) reset the 0 mode (come back to absolute mode)
 Init dyn : (Input) start a dynamic measure
 Characteristic status : (output) output a signal if the characteristics are ok
 Ctrl limit - : (output) output a signal if the part is in the lower control limit
 Ctrl limit + : (output) output a signal if the part is in the upper control limit
 - No Go : (output) output a signal if the part is out of the lower tolerance limit
 + No Go : (output) output a signal if the part is out of the upper tolerance limit
 Part status: (output) output a signal if the whole part (the 2 probes) respects
the tolerance limit.
 Class : (output) output a signal if the part is in the selected class
 Hold: (Input) freeze the screen to display the previous measure as long as the
input signal stay.
 Characteristic : (output) changes the displayed screen in the measuring screen