Bowers M1 - Page 85

M1 – M3 Display units
Page 85
The following screen appears on the M8 when a MB-RL is connected. There is a
function for each of the 8 ports, and these functions can’t be changed.
Input: start a
dynamic
measure
Output: output a
signal if the part
is out of the
tolerance max
Input: freeze the
measurement
screen and the
displayed value
Input: Set the
displayed value
to zero
Input: Transfer
the measured
value (need a
USB or RS232
link)
Input: Set the
displayed value
to the master
value
Output: output
a signal if the
part is out of the
tolerance min