Bpt mitho+ - Maintenance and Use of the Terminal; Gateway OH;GW; Technical Features

61
Technical Manual
GB
Maintenance and Use of the Terminal
ATTENTION
• Only use soft, dry or slightly damp cloths to clean the terminal; do not use any chemical products.
• Use the terminal only with the pen provided or with similar instruments. Do not use tools, pens or other
sharp instruments which may damage the display and compromise operation.
• Do not expose the LCD screen to direct sun light.
Gateway OH/GW
Device that lets you interface the network of terminals connected on Bus MultiMaster (MM) with BPT electri-
cal automation and Brahms anti-intrusion security B2 and C4 systems.
For the part for interface with BPT electrical automation systems, you can connect:
- without Bus NH-RBB repeater
- 1 power supplier OH/A.01 and 38 modules of BPT generic electrical automation;
- with Bus NH-RBB repeater
- 1 power supplier OH/A.01 and 78 modules of BPT generic electrical automation.
Each gateway is counted as 1 home automation node.
NOTE. In connections with NH-RBB repeaters, provide the following connection sequence:
- OH/A.01+38 modules+NH-RBB+40 BPT electrical automation modules.
For the anti-intrusion security part, the B2 and C4 control units are connected via a serial interface.
Technical Features
• Power supply 12÷24 V DC
• Absorption:
70 mA at 12 V DC
50 mA at 18 V DC
45 mA at 24 V DC
• Operating temperature: from 0 °C to +35 °C.
• Dimensions: low-profile 4-unit module for installation on DIN rail.
ManTecnico_MithoPlus IT_GB 2484561 61ManTecnico_MithoPlus IT_GB 2484561 61 18-06-2008 11:50:0918-06-2008 11:50:09