Brady BBP 85 - Installing Software Upgrades; Upgrade from a PC

7-6 BBP
®
85 Label Printer User’s Manual
Installing Software Upgrades
Upgrade from a PC
Installing Software Upgrades
Upgrade from a PC
Use this procedure to upgrade your printer to a new version.
To upgrade:
1. Before installing, verify the following:
• Upgrade Utility is available on your PC or via www.bradyid.com/support .
•
USB cable is connected from your BBP
®
85 Printer to your PC.
• Printer is
ON .
Note: If the printer driver has not been installed on your PC, you will be
prompted to install the printer driver before continuing.
Note: If there are unsaved changes in the currently active file, the system will
prompt you to save the file before continuing with the upgrade.
2. On the PC, launch the upgrade utility.
3. In the Welcome dialog, select Next.
4. In the Select your printer dialog, select your BBP
®
85 Printer.
Note: If your printer does not have enough free space, you will be prompted to
install a USB Flash Drive with at least 64MB of free space.
5. In the Version Confirmation dialog, select Start Upgrade to accept the
upgrade or Cancel to exit.
Note: The printer restarts automatically after the upgrade is complete.
6. In the Success dialog, click Finish.