Need help?Do you have a question about the Brady BBP 33 and is the answer not in the manual?
General| Brand | Brady |
|---|---|
| Model | BBP 33 |
| Category | Label Maker |
| Language | English |
Formal summary of liability and terms.
Lists registered trademarks and brand names.
Details the product warranty terms and conditions.
FCC Notice-US Only, compliance details.
Class A product warning and RoHS Directive.
Bluetooth health and authorization.
Warnings about water and electrical storms.
FCC Class B digital device compliance.
Disclaimer for wireless performance.
Compliance with R&TTE Directive.
Country-specific wireless usage limitations.
WEEE Directive compliance information.
German WEEE compliance.
General safety precautions for printer use.
Regional Brady Technical Support contacts.
Describes keypad and interface buttons.
Lists key features and functionalities of the printer.
Lists compatible software applications.
Details printer's weight, dimensions, and operating parameters.
Describes the printer's user interface components.
Explains the two modes of the display screen.
Describes the main options in menu selection mode.
Instructions for unpacking and inspecting the printer.
Identifies and labels the printer's physical components.
Details how to connect the printer to a power source.
Instructions for installing or changing the ribbon.
Instructions for installing or changing media.
Procedure to advance and cut label stock.
Instructions for powering on the printer.
Steps to reset or reboot the printer.
Instructions for connecting the printer via USB.
Overview of network card installation.
Steps for configuring WiFi and installing drivers.
Steps for configuring Ethernet and installing drivers.
Addresses Ethernet connection failure.
Instructions for upgrading firmware.
Procedure for cutting media using the autocutter.
How to view printer configuration and font information.
Adjusting print energy for optimal results.
Adjusting the print speed.
Defining when the printer tears or cuts labels.
How to change the printer's display language.
How to change measurement units (inches/mm).
Resets printer settings to factory defaults.
Importing graphics for use on labels.
Deleting imported graphics and fonts.
Enabling password protection for settings.
Procedure to upgrade printer software from a PC.
Accessing diagnostic menus.
Downloading and printing label scripts from a USB device.
Steps to remove power and media.
Instructions for removing dust from the printer.
Instructions for cleaning the tearbar.
Instructions for cleaning the auto-cutter blade.
Instructions for cleaning the sensors.
Instructions for cleaning the printhead.
Instructions for replacing the media wiper.
Procedures for clearing jams.
Lists common printing errors and their causes/solutions.
Lists common hardware errors and their causes/solutions.
Lists media-related errors and solutions.
Lists ZPL commands for Job Control.
Lists jScript commands for Job Control and Objects.
Lists DPL commands for general commands.
To Next Page
