3-4 BBP
®
33 Sign & Label Printer
User’s Manual
Output Settings
Tear/Cut Settings
Print Speed
Print speed lets you adjust the speed setting from 1 to 4 inches per second (ips).
Optimal print speed settings are set automatically by the smart cell for the installed
media and should only be changed if you are experiencing problems. For
example, you can change print speed if you want to print graphics or other densely
populated labels more slowly to ensure complete coverage.
To set the print speed:
1. Press to go to the navigation menu.
2. Press S or T to scroll to Output Settings, then press .
3. Press T to go to Print Speed, then press .
4. Press S or T to select the print speed you want (choose between
1- and 4-ips).
5. Press to accept the change and return to the submenu.
6. When done, press W twice to exit to the main menu.
Tear/Cut Settings
These settings define when the printer expects to tear or cut labels in a print job.
Depending on the selected cut settings, the printer advances the label to tear/cut
between labels, at the end of the job, or never.
To set the tear/cut option:
1. Press to go to the navigation menu.
2. Press S or T to scroll to Output Settings, then press .
3. Press T to scroll to Tear/Cut, then press .
4. Press S or T to select the tear/cut option you want:
•
Label
= between labels
•
Job
= end of job
•
Never
= do not tear/cut
Note: If your printer has a tearbar, the media advances to the tear position and
waits for you to tear the media. If your printer has a cutter, the media advances
to the selected position and is automatically cut and ejected.
5. Press to accept the change and return to the submenu
6. When done, press W twice to exit to the main menu.
To Next Page
Loading...
