BBP
®
33 Sign & Label Printer
User’s Manual
A-7
DPL Supported Commands
Commands
DPL Supported Commands
Note: These commands conform Revision D, 2001 Datamax Programmer’s
Manual
Commands
Commands Descriptions DPL
Set Cut Amount By
(Command must be issued and a cut will not occur until
job is done.)
:
Set Continuous paper Length
<STX>c
Input Image Data
(Only value "B" is supported for "f" parameter.)
<STX>I
Enter Label-Formating Command
<STX>L
Set Printer Metric
<STX>m
Set Printer Inches
<STX>n
Print Time and Date
<STX>T
Label Format Mode
Set Format Attribute
(Only 2, "Transparent Mode" parameter is supported.)
A
Set Column Offset Amount
(The maximum BMP33 offset is .1", if a value larger is
entered, it will be set to .1")
C
Set Cut by amount
(See ":" command)
c
Terminate Label formatting Mode and Print Label
E
Heat Setting
H
Select Mirror Mode
M
Set Metric Mode
m
Set Inches Mode
n
Set Print Speed
(Only values A,C,E,G, 1 - w ips respectively are
supported. If an unSupported value is entered, it will
default to 2 ips.)
P
Set Quantity of Labels to Print
Q
Set Row Offset Amount
(See "C" command)
R
To Next Page
Loading...
