Brady BBP 33 - Upgrade from PC

BBP
®
33 Sign & Label Printer User’s Manual 3-15
Tools
Upgrade from PC
Upgrade from PC
Use this procedure to upgrade your printer to a new software or firmware version
from a PC connected to the printer.
CAUTION!
Do not interrupt power on either the printer or PC during the upgrade process.
To upgrade:
1. Before installing, verify the following:
• Upgrade Utility is available on your PC or via the Brady website (see
Technical Support and Registration in this manual for more information).
• USB cable is connected from your
BBP
®
33 to your PC.
• Printer is
ON .
Note: If the printer driver has not been installed on your PC, you will be
prompted to install the printer driver before continuing.
2. On the PC, launch the upgrade utility.
3. In the Welcome dialog, select Next.
4. In the Select your printer dialog, select your BBP
®
33.
5. In the Version Confirmation dialog, click Start Upgrade.
Note: The printer restarts automatically after the upgrade is complete.
6. In the Upgrade Complete dialog, click Finish.