2-12 BBP
®
33 Sign & Label Printer
User’s Manual
System Power
Rebooting the Printer
System Power
These procedures describe how to power-up the printer when starting from a non-
powered state (i.e., printer has been unplugged) and how to remove power from
the printer.
Note: With power removed (i.e., printer disconnected from power source), the
system clock retains its settings for about 30 days.
Starting Printer
•
To start printer from a cold state
: Plug the printer into a power source. The
system automatically recognizes the supply information for the installed media and
ribbon and the display panel indicates
Ready
.
Note: The
backlight for the display panel turns off after a pre-defined period of time.
•
To turn on the backlight
: Press any button.
Powering Off the Printer
When the system is shut down, the display turns off.
To completely remove printer power:
1. Disconnect the power cord from the printer.
To perform a soft power down:
1. Press and release . The screen goes blank and the backlight goes off.
Rebooting the Printer
Use this procedure to reboot the printer (e.g., if the screen freezes).
To reset the printer:
1. Press and hold for at least 5 seconds. The system performs the
initialization process and restarts the printer.
2. When the Ready displays, you can continue printing your labels.
To Next Page
Loading...
