ENGLISH 14 / 78 CAP. 5 - INSTALLATION
Fill the bottle by paying special attention to the “oil care” valve.
This valve is made of a silicon polymer membrane; it compensates pressure variations within
the bottle and stops humid air infeed, thus preserving the new oil inside.
After filling, close the container and place it back in its seat.
5.1.9.2 Tracer container filling
The tracer is a substance made up of a yellow-green coloured fluorescent pigment, which
means that, when lit by an ultraviolet lamp, it becomes fluorescent and thus visible.
The tracer can therefore be used to detect small leaks inside the vehicle A/C system.
The tracer container is on the right, looking at the equipment from the front.
To fill it, it has to be extracted from its housing by means of the quick coupler on the top of
the container; slightly press downward the coupler ring nut to extract it.
Fill the bottle by paying special attention to the “oil care” valve.
This valve is made of a silicon polymer membrane; it compensates pressure variations within
the bottle and stops humid air infeed, thus preserving the new oil inside. After filling, close
the container and place it back in its seat.
To Next Page
Loading...
