ENGLISH 16 / 78 CAP. 5 - INSTALLATION
5.1.11 Setting working parameters and garage data
From the SETUP menu it is possible to select parameters and activations before starting cycles:
HYBRID FUNCTION
• by selecting this entry, one may change the type of Oil to inject into the A/C system
Attention: the HYBRID KIT PRO (optional accessory) is required in order to run this function
ECO LOCK®
• by selecting this entry, you can enable the ECO LOCK® function (the ECO LOCK® quick
coupler must be present on the car).
PRESSURES ZERO
• by selecting this entry, one may carry out calibration of the atmospheric pressure.
RECHARGE MODE
• by selecting this entry, one may decide whether to enable use of the Quick Mode or Zero
Tolerance recharge method
RECOV. GAS AND OIL PRINTING
• by selecting this entry, you can choose whether you want to enable displaying and printing of
the recovered gas quantity.
VESSEL HEATING
• by selecting this entry, one may decide whether to enable use of the heating band during the
vacuum phase.
MULTIPASS
• by selecting this entry, one may decide whether or not to enable the multipass function,
which enables an additional recycling, within the station itself, started automatically when it
is switched on but not in use. This function ensures a higher level of purity of the recycled
refrigerant to the advantage of the service quality.
PRESSURE CHECK
• by selecting this entry, one can enable or disable the pressure check.
DISPLAY CONTRAST
• by selecting this entry, you can change the display contrast level.
HOSES LENGTH
• by selecting this entry, it will be possible to change the length of the charge hoses.
UNIT OF MEASURE
• selecting this entry, you can modify the pressure unit of measurement (switching from Bar to
PSI)
CLOCK ADJUSTMENT
• by selecting this entry, date and time of the station may be changed.
GARAGE DATA
• by selecting this entry, one can enter the garage data to be printed on the end of cycle
report.
To Next Page
Loading...
