Enabling the Drive System
20 Basic Operation and Riding
Basic Operation and RidingEnablin g the Drive System
PREPARATION
The Empulse has many safety features designed to keep the drive
system disabled until you are ready to ride. Before enabling the drive
system:
1. The ignition switch must be in On position.
2. The kickstand must be up.
3. The Start/Off switch must be in the On position.
The drive system on the Empulse will not be enabled unless these
conditions are satisfied. If the Empulse’s drive system is enabled and
one of these conditions is not satisfied, e.g., the kickstand is down,
the drive system will be disabled.
ENABLING THE DRIVE SYSTEM
1. Insert the key into the ignition switch.
2. Turn the ignition switch clockwise to the On position.
3. The Empulse start-up tone will sound and the indicator lights on
the instrument cluster will illuminate briefly as a system check.
4. The amber ON indicator will remain illuminated.
Note: If the KICKSTAND DOWN message is displayed on the LCD, the
Empulse will not go into Drive mode.
5. It is recommended that you always make sure that the Empulse
is in N (Neutral) before engaging the motor controller.
Empulse.book Page 20 Thursday, June 27, 2013 11:03 AM
To Next Page
Loading...