Disabling the Drive System
Basic Operation and Riding 27
Disabling the Drive System
DISABLING THE DRIVE SYSTEM
There are a couple of different ways to disable the drive system:
• If the kickstand is put down, the drive system will be temporarily
disabled (the LEDs will stop flashing). If the kickstand is then put
up, the drive system will be enabled again (the LEDs will resume
flashing).
• Set the Start/Off switch to the Off position. This will switch off the
drive system. You will need to follow the procedure for enabling
the drive system before you can ride the Empulse. See “
ENABLING
THE DRIVE SYSTEM”, p a g e 2 0 .
TURNING THE EMPULSE OFF
1. Set the Start/Off switch to the Off position to disengage the drive
system.
2. Turn the ignition key counter clockwise to the Off position.
The Empulse will now power off.
Empulse.book Page 27 Thursday, June 27, 2013 11:03 AM
To Next Page
Loading...
