Maintenance
56 Servicing and Maintaining Your Empulse
BRAKES
Your Empulse is equipped with a front and rear hydraulic braking
system.
As the brake pads wear, the brake fluid levels will drop. A leak in
either of the systems will also cause the level to drop. Frequently
inspect the systems to ensure there are no fluid leaks.
Periodically inspect the brake fluid levels and the brake pads for
wear. If the brake lever or brake pedal freeplay does not feel within
the normal range while riding, check the brake pads for wear.
Worn pads should be replaced. If the pads are not worn beyond the
recommended limit, there is probably air in the brake system. See
your Brammo Authorized Dealer to have the air bled from the
system.
Recommended Brake Fluid
The recommended fluid is DOT 4 brake fluid. Be sure to read the
label before opening the sealed container.
Fluid Level Inspection
Note: Before commencing any work on your Empulse, refer to “
SAFETY
PRECAUTIONS”, p a g e 3 6.
Place your Empulse in an upright position on a firm, level surface.
Front brake fluid reservoir: The sight glass should be a solid dark color
all the way to the top. Rock the bike slightly to check the level.
WARNING
Brake fluid is highly toxic; keep containers sealed and out of the
reach of children. If accidental consumption of fluid is suspected,
seek medical attention immediately.
If the fluid comes into contact with the skin or eyes, rinse
immediately with plenty of water.
Brake fluid can damage plastic and painted surfaces. Handle with
care, and wipe up spills immediately.
WARNING
Only use new brake fluid from an airtight container. Fluid from open
containers or previously bled from the system will have absorbed
moisture, which will adversely affect performance and must not be
used.
Empulse.book Page 56 Thursday, June 27, 2013 11:03 AM
To Next Page
Loading...
