Brammo Empulse - Front Forks - Empulse R

Maintenance
54 Servicing and Maintaining Your Empulse
Front Forks - Empulse R
Spring preload adjustment nuts. Adjusting the preload lets you
change the “unloaded” sag of the suspension system
• Turning the nut clockwise increases the spring preload and
reduces the “unloaded” sag of the suspension system.
• Turning the nut counter-clockwise decreases the spring preload
and increases the “unloaded” sag of the suspension system
To adjust the spring preload, always start from the minimum preload
position (nut turned fully counter-clockwise). Take note of number
of turns and adjust both forks equally.
Note: Factory setting= three full turns in from the full out position.
Rebound damping - rotate the adjuster screw clockwise to stiffen
the damping (+) and counter-clockwise to soften it (-).
Note: Factory setting= two full turns out from the full in position.
Compression damping - rotate the adjuster screw clockwise to stiffen
the damping (+) and counter-clockwise to soften it (-).
Note: Factory setting= two full turns out from the full in position.
Empulse.book Page 54 Thursday, June 27, 2013 11:03 AM